Press Release
Rebuilding of your old Winslow Drill Point Grinders and Splitters
Posted on April 15, 2024
Winslow Engineering can rebuild your old Winslow Drill Point Grinders or Drill Point Splitters? They may have names like Winslomatics, Exactamatic, HC 101, 100B, G&L or Giddings & Lewis Drill Bit Sharpeners, also called...
Tap End Grinder
Posted on March 8, 2024
We designed and built a machine for grinding the ends of taps. It is an automatic machine. It requires only manual loading of the taps. The operator selects the tap size on the operator interface, loads the taps either in the...
Model 950 Tool Shank Flat Grinder
Posted on January 13, 2024
The Winslow Engineering Model 950 Tool Shank Flat Grinder was designed and built by Winslow Engineering. A cutting tool manufacturer came to us to see if we would be able to build a machine to grind three symmetrical flats at...
Winslow Engineering Can Rebuild or Recondition your Cutting Tool Inspection System
Posted on January 5, 2024
Winslow Engineering can clean, repair, or rebuild your Cutting Tool Inspection 550 & 560 Tool Analyzers. Often times the optics are dirty and require cleaning or slides may be loose and require tightening. Contact Winslow...
Winslow Model HR Drill Grinder Motions
Posted on September 26, 2023
The Winslow Engineering HR Drill Point Grinder's grinding cycle motions! The Winslow Model HR Drill Point Grinder. It is capable of grinding HSS and carbide drills in the size range of 1/6" - 1 1/2" (1.55mm - 38mm) diameter. It...
530 Benchtop Drill Point Splitter
Posted on August 30, 2023
Why split your drills by hand when you can use our 530 Benchtop Drill Point Splitter to obtain a consistent quality split on drills in the size range from 1/8" - 1/2" (3 - 13 mm) diameters. The Model 530 can split HSS and carbide...
Winslow Engineering's 560 PA Cutting Tool Inspection
Posted on May 4, 2023
Do you have a need to inspect parts in your CNC Tool & Cutter Grinder rather than taking them out, loosing your setup and walking to the inspection department? Contact Winslow Engineering for information on our 560 PA Video...
Why send your Drills out for Resharpening?
Posted on September 13, 2022
Why send your used drills out for resharpening? Keep the work in house to control quality and timely return of the resharpened drills.This is our rebuilt semi-automated Winslow Model HC Drill Point Grinder. It is capable of grinding...
The "NEW" Winslow Engineering Model 560G Cutting Tool Inspection System
Posted on July 6, 2022
Our new low cost Model 560G Video Tool & Part Analyzer permits rapid precise inspection of all tool/part geometry characteristics in new tool, tool regrind, and part manufacturing. The 560G vision system uses a series of lenses...
The New "Robot AutoInspect" Cutting Tool Inspection
Posted on April 27, 2022
The "NEW" Winslow Engineering Robot AutoInspect Cutting Tool Inspection System was first shown to customers at Eastec 2019 in West Springfield, MA. The Robot AutoInspect Cutting Tool Inspection System was programmed to remove...
